Takahashi EM400 12V Power Cable

This cable provides power to a Tak EM400 mount from a cigarette lighter socket.

They have a 3A reset-able electronic fuse backed up by a conventional 8A fuse and are constructed using a heavy gauge cable to minimise power drop, it is also fitted with an interference suppressor to minimise electrical noise for the Temma 2.

Theses are available in the following lengths 2m, 3m, 5m, 8m & 10m

(other lengths are available to special order. Please email to enquire about pricing)

 Cable Length

    Code

Cost

DC power Converter for Takahashi EM400

This DC - DC converter will provide the 24V required for the enhanced slewing on the EM400 mount.

It runs from a standard cigarette lighter output and is switchable to provide the following output voltages 12V, 15V, 18V, 21V & 24V at up to 2.5A, which is more than sufficient for the 24V @ 1.4A required by the EM400

(please email for more information).

Cost

DCCONVM/T

Takahashi Temma2 Serial Cables

Awaiting Picture

These serial cables allow the Temma2 controller on the mount to be connected to a PC or Laptop for control via Planetarium or guiding software.

Theses are available in the following lengths 2m, 3m, 5m, 10m & 15m

(other lengths are available to special order. Please email to enquire about pricing)

 Cable Length

    Code

Cost

Stainless Steel Counterweights for EM200 & EM400

These counterweights are specifically made to fit the EM200 counterweight shaft and are made from Stainless steel with a stainless locking bolt and a brass pin to prevent marking the shaft. The standard sizes are 5.2Kg reduced diameter 4" (as shown in the picture), 5.2Kg standard diameter 6", 12.5Kg standard diameter and 16Kg standard diameter.

Other sizes are available to order so if you have a specific requirement please email us with your requirements

As counterweights are only made to order please allow a minimum of 28 days for manufacture and delivery.

 Counterweight Size

    Code

Cost

 Counterweight Size

    Code

Cost